That is usually accomplished via a CAT control cable from your computer to your radio which is completely separate from the Signalink.
JT65 HF SOFTWARE DOWNLOAD SOFTWARE
The software must also be able to put your radio in transmit mode, and turn off trasmit mode. The 'Audio output device - Transmit' should be the device named 'Speakers (USB Audio CODEC ) which corresponds to the Signalink audio output device that sends the digital tones to your radio.Īll software programs that you use for digital modes MUST BE CONFIGURED TO USE THOSE DEVICES when you use the Signalink and all should work fine. The 'Audio input device - Receive' should be the device named 'Microphone (USB Audio CODEC ) which corresponds to the Signalink audio input device that captures the received audio signal from your radio. Here is a screen capture of the configuration dialog window: You also need to choose the correct audio devices in the software for RX and TX, which was mentioned by another poster, and the software should see the audio from your radio. This USB sound card will handle the Receive (RX) audio from your radio and deliver it to the software to be decoded, and send the transmit (TX) audio consisting of encoded tones from the software to your radio.
JT65 HF SOFTWARE DOWNLOAD DRIVER
The Signalink contains a USB sound card that will be a new sound device in your computer's Device Manager once the driver has been installed. The Signalink also needs to be plugged into a USB port on your computer using the supplied USB cable, and the driver for the Signalink must be installed on your computer for it to work properly. I have both a Signalink USB and a Rigblaster Pro.įor the Signalink to work, you need the correct Signalink cable that plugs into the back of your radio (I will assume that you have it, and it is plugged into the correct port on the back of your radio and into the RJ-45 jack on the Signalink). etc., so PLEASE DON'T GIVE UP! If what I tell you doesn't work, send me an email with a contact phone number (my email address is on QRZ.com for K4VBM) and I will be happy to call you and help you troubleshoot to get it working to pay it forward for my Elmer helping me. It can be very frustrating! Once you get the set-up right, all the digital modes should work, including PSK31, JT-65, RTTY, FT-8. Don't panic or give up - you are bringing back my not so good memories of when I tried to get digital modes to work on my radio and computer - thank goodness I had an Elmer that got on the phone with me, and talked me through the set-up. Unlike WSJT which (if set to wide decode) only decodes the strongest message, W4CQZs JT65-HF software will.